External polishing machine push-pull
WH-PDW-Z end face outer polishing machine (push-pull type)
Operation method: 1. Use the manual mode on the text screen of the electric box: select the corresponding fixture according to the size of the workpiece, the middle ejector and the clamp should be screwed; each polishing head moves the lower carriage according to the size of the workpiece to make the polishing wheel Suitable for polishing the workpiece, the polishing head can be oscillated according to the taper of the workpiece. The polishing head can choose vibration or no vibration according to the requirements of the workpiece. After adjusting the position of the polishing head, set the polishing head on the text screen of the electric box. Polishing time.
2. Use the automatic mode on the text screen of the electric box: place the workpiece, press the foot switch, the clamp is under the action of the cylinder, the ejector pin clamps the workpiece, the workpiece rotates, the polishing head starts, and the workpiece is under the action of the cylinder. It is sent to the end surface polishing head and the side polishing head for polishing. The end surface polishing head is pressed by the cylinder, the polishing wheel is pressed down, fixed polishing or left and right swing polishing, the side polishing head is under the action of the cylinder, and the round tube polishing machine is fixed by the polishing wheel. Polishing or oscillating polishing; After reaching the set time, under the action of the cylinder, the end surface polishing head polishing wheel is lifted, the cylinder sends the workpiece to the origin, the workpiece stops rotating, the clamp is loosened, and the workpiece is removed.