When the flat polishing machine display shows automatic, put the workpiece on the fixture, press the foot switch or switch, clamp the workpiece, the tail top is against the workpiece, the workpiece rotates, the grinding head rotates, and the servo motor drives the carriage forward (inside ), the servo motor drives the carriage to move to the left, the servo motor drives the carriage to the rear (outside), the polishing wheel rotates the surface of the workpiece according to the automatic simulation track, the servo motor drives the carriage forward (inside), and the servo motor drives the carriage Move to the right, the servo motor drives the carriage back to the original point (the outer), the workpiece stops rotating, the grinding head stops rotating, and the clamp and the tail end release to take out the workpiece.
When the flat polishing machine display shows automatic, put the workpiece on the fixture,press the foot switch or switch, clamp the workpiece, thetail top is against the workpiece, the workpiecerotates, thegrinding headrotates, and theservomotor drives the carriage forward(inside ), theservomotor drives the carriagetomoveto the left, theservomotor drives the carriage to the rear(outside), thepolishing wheel rotates thesurface of the workpieceaccording to the automatic simulation track, theservomotor drives the carriage forward(inside), and theservomotor drives the carriageMoveto the right, theservomotor drives the carriage backto the original point(the outer), the workpiece stops rotating, thegrinding headstops rotating, and theclampand the tail endrelease totake out theworkpiece.