Jiangmen Pengjiang Weisheng Machinery Co., Ltd.
13902889706
956182975@qq.com
Inner and outer round polishing machine

Inner and outer round polishing machine

The structure of the WH-PPW150 end face outer polishing machine PPW150 consists of three parts: the base part, the workpiece part and the polishing wheel set. 1 base part - mainly used to support the workpiece part, polishing wheel set and other components; 2 workpiece part - in this part, the sliding seat is moved forward and backward by the stepping motor, ball screw and nut, and the intermediate stepping motor is also used to drive the workpiece to rotate, and the workpiece is clamped by the suction structure; 3 Polishing wheel set - the main motor drives the polishing wheel shaft to polish the workpiece, and the cloth wheel can be made

Details

WH—PPW150 end face outer polishing machine

Structure of PPW150

It consists of three parts: the base part, the workpiece part and the polishing wheel set.

1 base part - mainly used to support the workpiece part, polishing wheel set and other components;

2 workpiece part - in this part, the sliding seat is moved forward and backward by the stepping motor, ball screw and nut, and the intermediate stepping motor is also used to drive the workpiece to rotate, and the workpiece is clamped by the suction structure;

3 Polishing wheel set——The main motor drives the polishing wheel shaft to polish the workpiece. The cloth wheel can be adjusted at a certain angle to meet the requirements of the workpiece. The left and right moving mechanism is also installed on the polishing wheel set and can be adjusted vertically. Structure.

The main technical parameters:
Dimensions: 800 × 700 × 1800mm
Voltage: 380V
Power: 3.2KW (1—3KW, 1-200W)

Electric box: PLC control system for consumables: hemp wheel, nylon wheel, cloth wheel consumables specification: outer diameter 4" (φ100mm) inner hole: φ25mm or φ10mm
Scope of application: Suitable for the outer surface of a round workpiece with a shallower diameter below φ80-φ150mm. The working principle is: the workpiece is rotated after the workpiece is clamped automatically (intake), and the table is automatically fed to the lower end of the polishing head, polished for a few seconds or After several times, the inner hole is thrown up and down, and after a few seconds or several times of polishing, the workpiece is automatically rotated to stop the rotation of the workpiece and automatically release the workpiece (blowing).

[[TD-Recommended Products]]