The elbow polishing machine is a mechanical device used for polishing curved tubes, curved rods, and the like, and is widely used in workshops, but there are also problems like this, the workshop is dusty, so the effective polishing sequence plus dust removal Equipment, from the inside out, from top to bottom, can solve the above problems:
1. When installing the elbow polishing machine, clean the ground as much as possible to prevent the machine from being installed and not easy to clean. Avoid high-voltage transmission lines and avoid interference with the electronic polishing machine. An independent power supply is required to avoid sharing with other high-power appliances.
2. The polishing machine installation requires a relatively large installation site, and it is important to have sufficient operating space. It is rainy, humid, and the polishing machine installed in areas such as saline and alkali cannot be placed on ordinary mud. Otherwise, many problems such as ventilation and drainage should be considered.
3. When the polishing machine is running for a long time, the polishing roller conflicts with high heat temperature, which is easy to burn the leather surface and needs to be cooled before operation. Before and after the operation, the surface of the polishing roller should be cleaned and waxed to keep the roller surface smooth and dust-free.
4. During operation, the pressure of the feeding roller is controlled to avoid too much resistance, and the appliance is heated and burnt. Do a good job of the smooth rolling parts of the transmission chain, and insist on the transmission.
5. Use medium abrasive with wool disc grinding, then grind with fine abrasive and sponge ball
6. During the polishing operation, the speed of the polishing machine should be strictly controlled. For skilled technicians, the paint surface of the steel plate can be controlled between 2500-4000 rpm and the plastic part paint surface does not exceed 1800 rpm. For unskilled technicians, the paint surface of the steel plate should be controlled between 1500-2500 rpm, and the plastic part paint surface should be controlled between 1000-1200 rpm. Otherwise, the high temperature caused by the excessive speed may cause damage to the paint surface, and even throw away the original paint surface, causing irreparable damage.
The above is the correct polishing knowledge of the elbow polishing machine.
